Signed in as:
filler@godaddy.com
Signed in as:
filler@godaddy.com
EEG professionals are certified to conduct home inspections, take samples of suspected material, and assess its condition. We then produce a report that summarizes the findings and advises about what corrections are needed. We will also advise you on who is qualified to make these corrections. Often these reports are needed for securing a residential renovation or demolition permit.
Some firms offer combinations of testing, assessment, and correction. A professional hired to assess the need for corrective action should not be connected with an asbestos-correction firm. EEG only provides the testing and assessment service.
What is Asbestos?
Asbestos is a mineral fiber. It can be positively identified only with a special type of microscope. There are several types of asbestos fibers.
Where is Asbestos found and when can it be a problem?
In the past, asbestos was added to a variety of products to strengthen them and to provide heat insulation and fire resistance. Most, but not all, home building materials made today do not contain asbestos. However, up until 1978, the production of many types of building and insulation materials used in homes contained asbestos. Products produced prior to 1978 and even some imported building materials after 1978 are sometimes found in homes built after 1978. Common products that might have contained asbestos in the past include:
·Steam pipes, boilers, and furnace ducts insulated with an asbestos blanket or asbestos paper tape. These materials may release asbestos fibers if damaged, repaired, or removed improperly.
· Resilient floor tiles (vinyl asbestos, asphalt, and rubber), the backing on vinyl sheet flooring, and adhesives used for installing floor tile. Sanding tiles, scraping or sanding the backing of sheet flooring during removal can release fibers.
· Cement sheet, millboard, and paper used as insulation around furnaces and wood burning stoves. Repairing or removing appliances, cutting, tearing, sanding, drilling, or sawing insulation may release asbestos fibers.
· Door gaskets in furnaces, wood stoves, and coal stoves. Worn seals can release asbestos fibers during use.
· Soundproofing or decorative material sprayed on walls and ceilings. Loose, crumbly, or water-damaged material, and sanding, drilling, or scraping the material may release fibers.
· Patching and joint compounds for walls and ceilings, and textured paints. Sanding, scraping, or drilling these surfaces may release asbestos.
· Asbestos cement roofing, shingles, and siding. Some roofing and siding shingles are made of asbestos cement. Houses built between 1930 and 1950 may have asbestos as insulation. Asbestos may be present in textured paint and in patching compounds used on wall and ceiling joints. Their use was banned in 1977. These products are not likely to release asbestos fibers unless sawed, drilled, or cut.
How to identify materials that contain Asbestos
You cannot tell whether a material contains asbestos simply by looking at it, unless it is labeled. Even though an experienced professional inspector can identify suspect material for containing asbestos it can only be determined by sample analysis. Since a professional knows what to look for, and because there may be an increased health risk if asbestos fibers are released when sampling is done incorrectly, you should always hire a professional.
East Environmental Group Inc
499 South Warren Street Suite 500, Syracuse NY 13202
office 315.810.2433 fax 315.475.1752
Copyright © 2020 East Environmental Group Inc - All Rights Reserved.
Powered by GoDaddy Website Builder